Tools
Deterministic engineering tools
Every figure here comes from a pure, unit-tested engine, never the language model. Run them directly, or start a prototype and the studio routes your spec to the right tool and pre-fills your inputs.
Not sure which tool you need?
Drop a spec, load list or design pack and the assistant suggests the right tools and pre-fills them.
Size and study
Turn loads into currents, conductors and fault levels.
Load schedule
AvailableConnected and diversified loads → kVA, full-load current and a spare-capacity design current.
Open Load schedule →Cable sizing & volt drop
AvailableSmallest standard conductor CSA that stays within your voltage-drop limit, from first-principles resistance.
Open Cable sizing & volt drop →Fault level & discrimination
AvailablePreliminary prospective three-phase short-circuit current from the transformer source (IEC 60909, simplified).
Open Fault level & discrimination →Draw and visualise
Generate preliminary diagrams and a 3D panel from a description.
Block cable diagram
AvailableGenerate a preliminary block cable diagram (downloadable SVG) from a system description. AutoCAD export on the roadmap.
Open Block cable diagram →Single-line diagram
AvailableGenerate a preliminary single-line diagram (downloadable SVG) from a board description: supply, main device and outgoing ways. AutoCAD export on the roadmap.
Open Single-line diagram →3D panel visualiser
AvailableDescribe a control panel, MCC, feeder pillar or junction box and get an interactive 3D model plus a dimensioned 2D GA (PNG, glTF, SVG and AutoCAD DXF downloads).
Open 3D panel visualiser →Control schematic
AvailableGenerate a preliminary ladder control schematic (downloadable SVG) from a description: start/stop stations, interlocks, lamps and valves, IEC-style symbols.
Open Control schematic →Specify and evaluate
Build a candidate bill of materials and check it before issue.
BOM & component selection
AvailablePreliminary bill of materials from an approved component library with brand presets; CSV export in AutoCAD Electrical-friendly columns.
Open BOM & component selection →Compliance checklist
AvailableInternally-authored BS 7671 / IEC 60204-1 / 61439 pre-issue checklist: a prompt for the engineer, not a substitute for design verification.
Open Compliance checklist →Preliminary and unverified. These tools produce reproducible first-pass figures from the inputs you give. A competent engineer confirms the assumptions and the final design against BS 7671 and the relevant IEC standards before anything is issued.